toyota forums   toyota forums

Go Back   Toyota Forum > Toyota Forums (Toyota Vans) > Toyota Previa Forum

Toyota Forum: Tailshaft and Driveshaft Repair - Help Needed
Reply
 
Thread Tools Display Modes
  #1  
Old 07-06-2019, 02:12 AM
[email protected]@bl3s b@dv3g3t@bl3s is offline
Junior Member
 
Join Date: Jul 2019
Posts: 2
Default Tailshaft and Driveshaft Repair - Help Needed

Hello fellow Toyota Enthusiasts and more specifically Previa owners (past, present, future) or anyone with knowledge about my question/s. So there's a lot of backstory to my Toyota Previa but to make a long story short suffice to say I love my Previa and I'm willing to do whatever it takes to get it back up and running again. Yes, it's been sitting for several months now I hate to admit.

It all started one day when I was driving down the road and I heard a really loud commotion coming from under the van. Yes, the driveshaft u-joint snapped sending the shaft into my gas tank where it punctured that as well as taking out an 02 sensor on the way. Also yes, there was vibration before that should have alerted me that my driveshaft was in need of service but I continued to drive the van pretty regularly anyway. That is my mistake and I take full responsibility for that.

Anyways the question/s is/are basically this: How would I go about making this repair? The ujoint broke at the joint by the "tailshaft" (?) My plan was to just unbolt the old tailshaft from the transmission, install a new tailshaft on the transmission, and then rebuild the driveshaft and reinstall like that...

I was planning on trying to just buy the tailshaft part of the transmission new and bolt it on. However I can't find just the tailshaft of the transmission for sale. Should I just go to a junkyard and try to find a used one and driveshaft and install on my van?

Is my line of thinking or plan for the repair wrong? Any help, or insight into my issue would be great appreciated.

BTW I'm not looking for advice on how to repair the gas tank or 02 sensor. Just the tailshaft and driveshaft. Also my van is a 1992 2.4L supercharged RWD version.
Reply With Quote

  #2  
Old 08-05-2019, 04:19 PM
SpaceTurtle95 SpaceTurtle95 is offline
Junior Member
 
Join Date: Aug 2019
Posts: 1
Default

I recently had a similar failing u-joint on a 95 SC AWD. After some research it seemed like the easiest solution was to replace the entire driveshaft instead of trying to fix individual parts.
The whole drive shaft was about $300 and it didn't take me long to replace.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



All times are GMT. The time now is 12:54 PM.


Advertisements





Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.
toyotaowners.net recognizes that "Toyota", it's logos and various model names and numbers are registered trademarks of Toyota Motor Corporation. These terms are used for identification purposes only. toyotaowners.net is not affiliated in any way with Toyota Motor Corporation. or any other company listed herein. All information on this site is the opinion of its members and not the opinion of the site itself. ©2017 Madison Ross Media Group. All rights reserved. Content published on ToyotaOwners.net requires permission for reprint.
MADISON ROSS MEDIA GROUP MARKETPLACE
Need products for your Toyota? Check out your options at the links below: