I have a 2008 Sequoia and a new fob (keyless remote). I can not find the procedures to get the vehicle to accept the signal from the remote. I did find the procedures for a 2006 model, but it proved fruitless for my 2008. I also found a Technical Service Bulletin regarding the procedures but can't get the details for that bulletin.

EL010R-07 NOV 07 Keyless Entry - Remote Transmitter Programming Guide

I know there are several steps involved in opening the doors, cycling the ignition and cycling the door locks, but I need the full procedures.

Hi,
I'm in the same exact boat... Did you ever figure this out? If so, would you mind sharing the specifics with me? Thanks in advance!

Scott