Right then, I am currently working on my Hiace camper - It's a standard panel van but I am adding some bits n pieces to make a basic camper out of it :)

It has a bulkhead fitted between the cab and the rear load bay. Would this be strong enough to use to fit a bed to?
I am thinking of a hammock type of afair to begin with, attached to the four corners of the van - the rear should be fine as I can thread a rope through the frame work over the double rear doors and attach the two rear corners of my bed to that. I am just not so sure the Bulkhead will be strong enough to attach to the top two corners of that for the front corners of the bed...

What to people think? Is there some sort of easily accesable framework around where the bulkhead is?
Or do I need to go back the the drawing board and have a total re-think?
Anythink obvious I've missed out here...

Cheers!!
CC